Temporary Power Distribution Boards

Power distribution units are used when the power infrastructure in the data hall is not in place, but you need to supply the power to carry out heat-load testing. 

Depending on the level of power you need, a range of power distribution units is available, from 230A to 630A.

We can provide two options of temporary 250A PDUs, which are compatible with all of our heat load units:

We can also provide temporary 630A PDUs, which distribute power to our 250A PDUs through our 95mm Cable Sets (up to 25M in length). These are fed by 240mm Cable Sets (between our 630A PDUs and the building’s power supply), which we can provide in lengths up to 20M.

Should you require an alternative temporary power distribution setup outside of our standard 230A to 630A range, we can utilise our extensive network of trusted partners to facilitate bespoke power distribution solutions tailored to your project requirements.

This enables us to support a wide variety of site configurations and commissioning environments, ensuring a flexible and reliable temporary power solution throughout your data centre heat-load testing programme.